BALL JOINT – Remove & Replace – 4WD Lower,One Side – [Includes: R&I Steering Knuckle.] – [DOES NOT include alignment.]
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing. Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
NEEDS LEFT REAR ABS WHEEL SPEED SENSOR AND THE HARNESS. T-CASE LEAKS IN MULTIPLE SPOTS FRONT DRIVE SHAFT NEEDS TO BE REPLACED REAR AXLE UPPER LOADING ARMS BUSHINGS ARE GONE
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
ALICIA S. gave our service a 5 star review on 11/5/2020
2007 Jeep Liberty CRM Mitchell1
2020-11-07T23:01:07+00:00
(Combination) – SHOCK ABSORBER MOUNT – Replace Each
SHOCK ABSORBER – Remove & Replace – Assembly,w/Air Suspension,Both – [Includes: Additional time for use of scan tool to perform this procedure.] – [DOES NOT include alignment.]
AMY M. gave our service a 5 star review on 6/26/2020
2015 Jeep Grand Cherokee CRM Mitchell1
2020-06-27T22:00:34+00:00
Change oil, filter and grease chassis. 21 point inspection.
FOUND CODES POO300 P0302 P0306. PULLED SPARK PLUG ON 2 AND FOUND TO BE WORN AND ALMOST 2 TIMES THE RECOMMENDED GAP. ALSO HAD HEAVY CARBON TRACKING FOUND THIS ALSO ON #6. REPLACED PLUGS AND ALL RUBBER BOOTS ON THE COILS. RUNS GOOD AND NO CODES AT THIS TIME.
SPARK PLUGS – Remove & Replace – V6
KAYLANA B. gave our service a 5 star review on 1/21/2020
2005 Jeep Liberty CRM Mitchell1
2020-01-22T23:01:57+00:00